free@home Heating Actuator, 6-fold, 230 V, MDRC
This devices has six channels and serves as an actuator for the activation of heating systems via conventional thermal actuating drives.
- Six channels for the activation of actuating drives.
- Per channel, each device supports voltages of 24 V AC up to 230 V AC (this makes the use of all conventional thermal actuating drives possible).
- Three channels can be protected together by a circuit-breaker.
Power supply: 24 V DC (via the bus)
Bus subscribers: 1 (12 mA)
Connection (free@home): Bus connection terminal: 0.4 - 0.8 mm
Line type: J-Y(St)Y, 2 x 2 x 0.8 mm
- 6 or 12 semiconductor outputs: 3 non-floating outputs each in the group. Protected against short- circuit and overload
- Rated voltage UN: 24 to 230 V AC 50/60 Hz
- Nominal current IN per output: 160 mA resistive load at TU to 45¡C
- Inrush current per output: Maximum 750 mA for 10 s at TU to 60¡C
- Caution: For the parallel connection of actuating drives (e.g. TSA/K) the technical data of the respective actuating drive is to be observed! The inrush current (750 mA) and nominal current (160 mA) of the output must not be exceeded.
- Combi-head screw-type terminal (PZ 1)
- Connection cross section:
- 0.2 - 4.0 mm2 fine-wire
- 2 x 0.2...2.5 mm2
- 0.2 - 6.0 mm2 single-wire
- 2 x 0.2...4.0 mm2
- Tightening torque: 0.6 Nm
- Operation: -5¡C to +45¡C
- Storage: -25¡C to +55¡C
- Transport: -25¡C to +70¡C
Environmental conditions: Maximum humidity: 93%, no dew permissible
Protection type: IP20 Acc. to DIN EN 60 529
Protection class: II Acc. to DIN EN 61 140
- Over voltage category: III acc. to DIN EN 60 664-1
- Degree of contamination: 2 acc. to DIN EN 60 664-1
Mounting: On 35 mm mounting rail. Acc. to DIN EN 60 715
Built-in position: Any
- Rail mounting device (MDRC): Modular installation device, Pro M
- Installation width: 4 or 8 modules a_ 18 mm
- Installation depth: 64.5 mm
- Housing, colour: Plastic, basalt grey (RAL 7012)
Dimensions: 72 x 90 x 64.5 mm (W x H x D)
Weight: 0.14 kg
CE marking: According to EMC and low-voltage guidelines